Standing seam and metal panel roofing, roof repair and full replacement in Plymouth. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Plymouth.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
If wind got under your roof once it will try again. We fix the damage and close the edge back up so there is nothing left to catch.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Plymouth homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Plymouth home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Plymouth homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
For most Plymouth homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
We do. After a storm we photograph the damage on your Plymouth roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Sometimes. If the decking is sound and there is only one layer of shingles, a Plymouth metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Plymouth metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Much less than people expect. Over solid decking with underlayment under it, a Plymouth metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Plymouth ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Real feedback from homeowners whose roofs we have worked on.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Very pleased with the roof. The only thing I would mention is that the estimate took a couple of days to come back, but once it did everything went right on schedule."
Our crews cover the surrounding area, not only the city limits.